Precautions for container transportation of plastic buckets

- Mar 12, 2020-

Plastic buckets are often used for the storage and transportation of goods. When using, it should be noted that most plastics are not strong in heat resistance, and will deform or even release harmful gases if the temperature is too high. Do not use PVC plastic bags to contain food, especially oil-containing food. It's difficult to recognize the safety of the new plastic products because of the disordered ingredients, and they can't be used to hold food. For plastic products, keep away from fire and avoid risk accidents such as fire.

For the recovery of plastic bucket, the crushing of plastic bucket is very important. We all know that plastic bucket is made up of bottle label, bottle cap and bottle body. The raw materials of these parts are different. Therefore, how to break the plastic bucket smoothly is very important. In addition, it's very troublesome to transport the plastic bucket after it's taken back, with high cost. Therefore, the broken plastic bucket is conducive to transportation.

When moving, it can adopt the direction of manual horizontal rolling and lateral moving. It has good anti-corrosion performance and is suitable for the packaging of a variety of risk products. After dumping, it has a small amount of residue and is easy to clean. It is suitable for repeated use for many times and has a long service life. Under the normal conditions of filling, transportation and loading and unloading, it can be used more than 20 times. The size meets the requirements of international packing and transportation. 20 foot containers can be loaded with 80 containers and can be used In hot filling, the general temperature does not exceed 60 ℃. After hot filling, the container should be cooled to room temperature before closing the lid and stacking.

The container shall be packed tightly and firmly, and it may have enough support and reinforcement. The manufacturer of each two layers of plastic bucket shall lay a layer of thin plate on the top before stacking to avoid fluctuation during transportation. The manufacturer shall lay a layer of thin plate on the top before stacking to avoid excessive collapse of local stress caused by fluctuation and collision during transportation and unnecessary loss. In the process of transportation, the ground should be flat to prevent the can body from skewing and damaging the can body with sharp objects. When filling and sealing, it is better to use a rubber hammer less than one pound. First, compress the opening of the tearing belt, and then knock down the cover evenly along the outer circumference of the top of the barrel cover. The knocking force is not allowed to exceed 8kg. The contact between the rubber hammer and the barrel cover should be parallel and not skewed, otherwise it is easy to break the barrel cover.